• 7
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • WHITE 9102
  • BLACK 9103
  • ASH GREY 9093
  • DARK GREEN 1458
  • EVERGREEN 1461
  • EXECUTIVE GREY 0104
  • GOLDEN YELLOW 0455
  • MISTY GREY 1457
  • NEPTUNE BLUE 9331
  • SIGNAL RED 1411
1

Nippon Paint EA7 Finish Epoxy Floor Paint 5L

Regular price
RM 143.90
Sale price
RM 143.90
Regular price
RM 149.00 - RM 159.00
Worldwide shipping | BITARA HARDWARE
Worldwide shipping
Secure payments | BITARA HARDWARE
Secure payments
Authentic products | BITARA HARDWARE
Authentic products
Nippon Paint EA7 Finish Epoxy Floor Paint 5L Ratings: 0 - 0 votes

NIPPON PAINT EA7 FINISH is a good performance two pack amine adduct cured epoxy coating that gives a glossy finishing appearance. This good performance finish makes it suitable to be applied on concrete substrates where adhesion to concrete is crucial and abrasion resistance is required.


PRODUCT FEATURES: 

• Good adhesion and good abrasion resistance

• Gloss finishing 


Paint Type: Solvent Base

Product Type: Interior

Finishing: Gloss ,Variety of Colours

Recommended Substrate: Properly primed steel, masonry and tile

Pack Size: 5 L (4.375 L Base and 0.625 L Hardener)


Pigment :  Organic and inorganic pigments

Binder : Epoxy and amine adduct

Thinner : Combination of aromatic, ketone and alcohol


Drying Time : Touch Dry : 3 - 4 Hours 

                       : Hard Dry : 16 hours


Overcoating Time :  Minimum 16 hours (Dependent on temperature and humidity)

No. of Coats : 1 - 3 coats


Mixing Ratio : 7 parts by volume of Base to 1 part by volume of Hardener. (Stir the content of the Base component, continue stirring and gradually add the total contents of the Hardener component, continue stirring until a homogeneous mix is

obtained.)


APPLICATION METHOD: 


Brush, roller, compressed air spray and airless spray. Preferably use airless spray if a thicker coat is required in one application. Brush, roller and compressed air spray generally lead to lower film thickness, so more applications may be required to obtain the recommended thickness per coat. When airless spray is being used, excessive high tip spraying pressure should be avoided. The minimum pressure at the pump conducive with good atomisation should be used. Brush and roller are recommended for small areas and touch-up only. Good quality brushes and mohair/ short nap rollers should be used with full strokes. Avoid rebrushing. Additional coats may be required to achieve minimum specified film thickness.


RECOMMENDED COATING SYSTEM: 


Concrete / Cement Floor

Primer : Nippon Paint Penetrative Epoxy Primer/ Nippon Paint EA9 Finish HB : 1 Coat

Top Coat : Nippon Paint EA7 Finish : 2 Coats


Steel

Primer : Nippon Paint  EA9 Red Oxide Primer : 1 Coat

Top Coat : Nippon Paint EA7 Finish : 2 Coats


Tile/Ceramic Surfaces

Primer : Nippon Paint Tile Primer/ Nippon Paint EA9 Finish HB: 1 Coat

Top Coat : Nippon Paint EA7 Finish : 2 Coats


Cleaning: SA-65 Thinner. Clean up equipment with thinner immediately after use


SAFETY PRECAUTIONS: 

• Keep container tightly closed and keep out of reach children or away from food and drink.

• Ensure good ventilation during application and drying.

• When applying paint, it is advisable to wear eye protection.

• In case of contact with eye, rinse with plenty of water immediately and seek medical advice.

• Remove splashes from skin by using soap or water.

• Paint must always be stored in a cool place.

• When transporting paint, care must be taken. Always keep container in a secure upright position.

• Dispose off any paint waste in accordance with the appropriate 

Reviews

Be the first to review